| Technical Data Rackmount key-panel stations
K4,
K7,
K12,
K18 and
KC4
KC6
KC7
KC12
|
| Dimensions |
2RU-19" depth 100mm without connectors |
| Buttons |
(K4) 8, (K7) 11, (K12) 16, (K18) 22, (KC4) 12, (KC6) 17, (KC7) 17, (KC12) 23 |
| Electronical parts |
SMD sub boards on a mother-board |
|
| Measurements (all audio measurements using 2
key-panel stations connected through a patch-panel) |
| Microphone amplifier |
input -46dBu at 4kOhm, signal to noise ratio better than 100dB with
reference to the input |
| Loudspeaker amplifier |
output 4V at 4Ohm, signal to noise ratio better than 78db with
reference to +6dBu output |
| Frequency Response |
160Hz - 10KHz -3dB |
| Distortion |
better than 1% |
|
| Microphone |
condenser swanneck 4,5mV/1PA/1KHz |
| Frontcontrol |
2 volume controls for main and aux |
| XLR 5F at front |
headset-connector, switches off the internal loudspeaker and microphone |
|
| Rear connector plate |
| (K4, KC4) connector A |
1x9 pin male sub-D to patch-panel (cable type 8 x .14mm² with shield) |
| (K7, KC6, KC7) connector A |
1x15 pin male sub-D to patch-panel (cable type 14 x .14mm² with shield) |
| (K12, KC12) connector A |
1x25 pin male sub-D to patch-panel (cable type 24 x .14mm² with shield) |
| (K18) connector A |
1x37 pin male sub-D to patch-panel (cable type 36 x .14mm² with shield) |
| Cable-length |
max. 5km using 2x.14 mm²
single talkback connections over normal coax cables are possible |
| Connector B |
1x9 pin female sub-D for aux, earth free in- and outputs +6dBu |
| Connector C |
1x15 pin female sub-D for parallel keypanel station connection (modulation) |
| Conversion Kit KP |
for parallel keypanel station |
| Connector DE |
2x 25 pin female sub-D for parallel keypanel station connection (control) |
| Connector FG (KC4-KC12) |
1x 25 pin male, 1x 25 pin female sub-D for 3-6 cameras, earth free in- and outputs +6dBu |
|
| Power supply |
230V AC, built in power supply 2 x 15V/1A chassis-euro-connector |
| Operating Temperature |
+5° to +40°C |
| Weight |
4 kg |
